Taking the Slide off the Receiver:

Link to: Installing Slide Trigger Kit Parts

Link to: Installing Receiver Trigger Kit Parts

Make sure the gun is unloaded and all ammunition is put away!

All parts should be installed by a certified Glock armorer.

Making sure the firearm is not loaded!

  • Again checking to make sure the pistol isn't loaded!
  • Point the firearm in a safe direction
  • Pull the trigger while pointed in a safe direction

Grasp and hold the gun as in (Figure 2) and pull back on the slide about an 1/8" Note: Do not pull back on the slide too far or you will reset the trigger and you will have to pull the trigger again.

While holding the slide back as in (Figure 2) pull down on both sides of the slide lock. You can then push the slide forward and remove it from the frame.

Link to: Installing Slide Trigger Kit Parts

Link to: Installing Receiver Trigger Kit Parts

Note: All parts in the instructions are stock and not Vanek Custom parts.